2.
Telangana Tenders
Biz value: INR 1.36 Cr
Bid Before:27 March 2023 3 Days to go
Research And Development Centre
supply of slotted 100 csk head, 100csk offset cruciform head, cheese head, hex socket head, hex head, grub screw, nut, anchor nut, m6 stud, m8 stud, m10 stud m, ins m10 stud rear, nca m8 stud, m12 stud, bolt, washers, plain washer, spring washer, offset cruciform bits - fabrication supply of externally internally threaded fasteners en24 steel esr grade Qty 158795
Tag a friend
Hashtag & Get Tender
Probable Participants
3.
Uttar Pradesh Tenders
Biz value: INR 1.18 Cr
Bid Before:27 March 2023 3 Days to go
Airports Authority Of India
Supply installation testing commissioning of dust, damp and vermin proof cubicle free floor, indoor type factory built sheet steel enclosed modular bolted construction, suitable for operation on 415 10% volts, 50 hz ac 3 phase 4 wire supply system fabricated out of crca sheet steel of 2.0 mm thick for frame work and 2.0 mm thick for doors/ covers, 3mm thick for gland plate including cleaning & finishing complete with 7 tank process for powder coating in approved shade, having tpn al. bus bars of high conductivity, dmc/smc bus bar supports, bottom base channel of section not less than ismc 75mm, entire panel shall have a common cu earth bar of suitable size with 2 nos earth studs, i/c control wiring with 1.5sqmm. pvc insulated frls copper conductor single core cable for voltage & 2.5sq.mm for current ckt, cable alleys, cable gland plates ,danger notice plates, etc. necessary metering protections & indications and mounted with the following switch gears., note provision for installation of external 3 phase spd to be provided in the panel (supply and installation of 3 phase spd is not covered in this item. i/c i) 2 no. 100 a 4p , mccb 36ka, ics is equal to icu is equal to 36 ka with thermal magnetic release having overload & short circuit protection equipped with extendable rotary handle and extendable terminals with the following a) 6 nos phase indication led lamps with 2amp mcb, on/off indicating light with 2a mcb mfm, class 0.5 with lcd display shown v,a,hz & pf - 2 nos. ats i) 1 no. 4 pole, 100 a ats bus-bar, tpn al. main bus bars of min 120 a capacity with heat shrinkable coloured sleeves & i/c dmc/smc bus bars supports at required intervals complete. o/g i) 3 no 63 a 4p, mccb 25ka, (ics is equal to icu is equal to 25 ka) with thermal magnetic release having o/l & short ckt protection equipped with extendable rotary handle with the following ii) 2 no 32 a tpn, mcb 10ka (iii) 2 no 16 a sp, mcb 10ka 4 set of on off indication lamps (led type) with 2 a control mcbs.", supply of 3.5 core x 300 sqmm xlpe insulated pvc sheathed armoured aluminium conductor cable of 1.1 kv grade confirming to is 7098 (part 1) with upto date amendment etc. complete as required., supply of aesthetically designed rechargeable led lantern with dimming & sos feature with minimum 5 watt, rechargeable li-ion battery capacity of 3.7 v, 4400 mah and suitable charging from 160-270v ac supply 50hz etc as required., laying of one number pvc insulated and pvc sheathed / xlpe power cable of 1.1 kv grade of size above 185 sqmm and upto 400 sqmm direct in ground including excavation, sand cushioning, protective covering and refilling the trench etc as required., laying of one number pvc insulated and pvc sheathed / xlpe power cable of 1.1 kv grade of size above 185 sq. mm and upto 400 sq. mm in the existing masonry open duct as required., laying and fixing of one number pvc insulated and pvc sheathed / xlpe power cable of 1.1 kv grade of size above 185 sq. mm and upto 400 sq. mm (clamped with 40x3mm ms flat clamp) on wall surface as required., laying of one number pvc insulated and pvc sheathed / xlpe power cable of 1.1 kv grade of size above 185 sq. mm and upto 400 sq. mm in the existing rcc/ hume/ metal pipe as required., supply and installation of floor mounting, totalling enclosed, compartmentalized, cubical, dust, vermin proof and outdoor type joint box for 300 sq.mm. armoured cable, ip-65 fabricated out of 2 mm thick cold rolled carbon annealed, sheet steel. comprising of 125 a al bus bar. height shall be 1.5 mtr enclosure size 500 mm x 500 mm x 250 mm powder coated ral-7035., supplying and making end termination with brass compression gland and aluminium lugs for size of 3.5 x 300 sq.mm. pvc insulated and pvc sheathed / xlpe aluminium conductor cable of 1.1 kv grade as required., earthing with g.i. earth plate 600 mm x 600 mm x 6 mm thick including accessories, and providing masonry enclosure with cover plate having locking arrangement and watering pipe of 2.7 meter long etc. with charcoal/ coke and salt as required., providing and fixing 25 mm x 5 mm g.i. strip in 40 mm dia g.i. pipe from earth electrode including connection with g.i. nut, bolt, spring, washer excavation and re-filling etc. as required., supplying and laying 25 mm x 5 mm g.i strip at 0.50 metre below ground in 40 mm b class gi pipe , including connection/ terminating with g.i. nut, bolt, spring, washer etc. as required. (jointing shall be done by overlapping and with 2 sets of g.i. nut bolt & spring washer spaced at 50mm)., providing & fixing of 25mm x 5mm gi strip on surface or recess for earth connection as required., providing, laying and fixing of 80 mm dia g.i. pipe (medium class) in ground complete with g.i. fittings including trenching (75 cm deep) and re-filling etc. as required, "supply and installation of pre-wired primary protection (class b/type 2) surge protection device (spd) having 100ka , 10/350 micro seconds neutral to earth, 50 ka...
Tag a friend
Hashtag & Get Tender
Probable Participants
6.
Karnataka Tenders
Biz value: INR 1.01 Cr
Bid Before:28 March 2023 4 Days to go
Gulbarga Electricity Supply Company Limited
Establishment of transformer repair center in the jurisdiction of o&m zone gescom kalaburagi (or in the existing repair center if already established in the jurisdiction of o&m zone gescom kalaburagi for other distribution transformers as per gescom award) and carrying out repairs to faulty 25/63/100 kva bee 4 star (star 1) distribution transformers of gescom as per gescom specifications by collecting from all the o&m divisional stores of o&m zone gescom kalaburagi and returning to respective the scope of work covers collection of faulty 25/63/100 kva bee 4 star (star 1) distribution transformers from concerned o&m divisional stores of o&m zone gescom kalaburagi, dismantling of transformer coils from the core and damaging all the three coils with cutter and releasing of transformer oil at the divisional stores in the presence of store keeper and the assistant executive engineer (ele) transformer repair monitoring gescom to keep the released oil with the concerned o&m gescom divisional store and lifting of released winding by the agency and shall be kept with the repairer (by collecting salvage cost of the released winding as quoted by the bidder). collection of transformer tank with core from the stores, repairing of the transformer by providing ht and lt winding by new coils, new ehv grade transformer oil as per gescom specification. replacing of bushing rods, metal parts, ht/lt bushing insulators, washers, gasket (which are unserviceable) and repairs of the tank, painting etc., drying the repaired winding in the oven as required, and testing repaired good transformer at the repair center. testing of repaired good transformer at divisional automatic test bench of gescom to ensure the quality of repaired good transformers as per gescom specifications by the assistant executive engineer (ele), transformer repair monitoring and handing over to the concerned divisional stores. the purchase order shall be placed by the executive engineer (ele), of the concerned gescom o&m division. the faulty transformers received from respective store shall be repaired and returned to the same stores
Tag a friend
Hashtag & Get Tender
Probable Participants
8.
Kerala Tenders
Biz value: INR 83.43 Lac
Bid Before:29 March 2023 5 Days to go
Village Panchayat
Supply of Material supply for mgnregs works, Beam clamp 300-380 mm (450-1070 mm) , Bitumen washer , Cheru narakam/Bamblose Narakam Seedling , Coarse sand (zone III) , Dry distemper , Epoxy paint , Fine sand (zone IV) , G.I Limpet washer , Galvanised steel bolts & nuts 6 mm dia and 25 mm long round head with slots , Galvanised steel J or L hooks 8 mm dia , Galvanised wire mesh of average width of aperture 1.4 and nominal dia. of wire 0.63 mm , GI trafford profile sheet 0.35mm thick , Grafted Jack Fruit Sapling , Grafted Mango Sapling , Interlocking C.C. paver block (80 mm thick, M-30) , Metal Primer (U.G.) , Mild steel tubes hot finished welded type , Multi surface paint , Portland Cement , Quarry Waste , Rambutan Sapling , Red oxide Zinc chromate primer , Sapota graft , Solid blocks of size 40x20x20cm , Stone Aggregate(single size) 06 mm nominal size , Stone Aggregate(single size) 10 mm nominal size , Stone Aggregate(single size)20 mm nominal size , Stone for masonry work , Twisted steel/deformed bars , Water thinnable cement primer for interior wall surface, having VOC content less than 50 gms/litre , Welding by electric plant , Wire nails , Polyurethene bags, Green Net 75% shade.
Tag a friend
Hashtag & Get Tender
Probable Participants
9.
Madhya Pradesh Tenders
Biz value: INR 79.80 Lac
Bid Before:30 March 2023 6 Days to go
Northern Coalfields Limited
supply of impeller part noup25066159, bearing housing de part noup25066240, bearing housing nde part noup25066253, sleeve nut part noup25066334, bearing nut part noup25066336, oil seal part noup25066500, insert de part noup25066979, set of o ring part noup25066ssor1, set of fastener part noup25066ssof1, split gland part noup25066229, top and bottom assembly part noup25066staba, casing ring part noup25066190, shoulder ring part noup25066199, wear ring part nosct3007719000, lantern ring part nosct3007722700, brg lock nut part nosct3007733600, lock washer part nosct3007741000, upper half casing part nosct3007712200, lower half casing part nosct3007712300, split gland part nosct3007722300, o ring part nosct3007752201, o ring part nosct3007752202, shaft sleeve d e bronze part no10uph4310, shaft sleeve nde bronze part no10uph4311, shaft sleeve nut part no10uph4334, bearing nut part no10uph4335, set of keys part noss0k110uph4, set of o ring part no10uph4ss0r1, set of fasteners part no10uph4ssof1, bearing lock nut part no10uph4336, split gland part no10uph4229, liquid diflector part no23610uph4 - kirloskar pump spares Qty 210
Tag a friend
Hashtag & Get Tender
Probable Participants
10.
Rajasthan Tenders
Biz value: INR 71.05 Lac
Bid Before:31 March 2023 7 Days to go
Rajasthan Rajya Vidhyut Utpadan Nigam Limited
Basket Frame Weldment For 3.160 Mtr Width Clear Basket Opening ( Material M.S. Epoxy Painted Other Than Black Colour) With Ss316 Wire Mesh,Clamping Flats,Fasteners And Support Pipes., Fluid Coupling, Complete Side Link Assembly( 1set Consistes Of 02nos. Each Of Side Link ( En-8) & Support Pipes(Ms),01 No Each Of Roller Bush & Link Pin (ss410&hdn),1 No Each Of Grease Nipple And 2 Set Of Bolt,Nut Washer ( Ss316for Fixing Of Basket On Each Link., Safety Pin Device, Drive Sprocket, Spacer, Drive Plate, Link Pin, Spare Of Tws Bcw Raw Water (tws 6), Basket Frame Weldment For 4.235 Mtr Width Clear Basket Opening ( Material M.S. Epoxy Painted Other Than Black Colour) With Ss316 Wire Mesh,Clamping Flats,Fasteners And Support Pipes., Complete Side Link Assembly( 1set Consistes Of 02nos. Each Of Side Link ( En-8) & Support Pipes(Ms),01 No Each Of Roller Bush & Link Pin (ss410&hdn),1 No Each Of Grease Nipple And 2 Set Of Bolt,Nut Washer ( Ss316for Fixing Of Basket On Each Link., Safety Pin Device, Drive Sprocket, Spacer, Drive Plate, Link Pin, Spare Of Tws Stg-Ii & Iii (tws 7-14), Basket Frame Weldment For 3.900 Mtr Width Clear Basket Opening ( Material M.S. Epoxy Painted) With Ss316 Wire Mesh,Clamping Flats,Fasteners And 02 Nos Support Pipes For Tws ( Drg. No. 438-1-2000&438-Ii-2000), Fluid Coupling, Complete Side Link Assembly( 1set Consistes Of 02nos. Each Of Side Link, En-8) & Support Pipes(Ms),01 No Each Of Roller Bush & Link Pin (ss410&hdn),, No Each Of Grease Nipple And 2 Set Of Bolt,Nut Washer ( Ss316for Fixing Of Basket On Each Link For Tws ( Drg. No. 438-1-2000&438-Ii-2000), Safety Pin Device For Tws, Drive Sprocket For Tws, Spacer For Tws, Drive Plate For Tws, Link Pin For Tws.
Tag a friend
Hashtag & Get Tender
Probable Participants