Latest Road Tenders

Material Purchase for MGNREGS Works -Quarry Waste, Stone Aggregate(single size): 40 mm nominal size, Stone Aggregate(single size):20 mm nominal size, Stone Aggregate(single size): 10 mm nominal size, Stone Aggregate(single size): 06 mm nominal size, Coarse sand (zone III), Portland Cement, Hire charges of Concrete Mixer 0.25 to 0.40 cum with Hopper, Vibrator (Needle type 40 mm), wall form panel 1250x500 mm, Corner angle 45x45x5 mm 1.50 m long, 100 mm channel shoulder 2.5 m long, Double clip (bridge clip), Single clip, M.S. Tube 40 mm dia, Stone for masonry work, Hire charges of Diesel Road Roller- 8 to 10 tonne, Interlocking C.C. paver block (80 mm thick, M-30), Mild steel tubes hot finished welded type, Red oxide Zinc chromate primer, Welding by electric plant, Synthetic enamel paint in black or chocolate shade, Solid blocks of size 30x20x15cm, Fine sand (zone IV), G.I pipes 50 mm dia, G.I. pipes 40 mm dia, G.I. pipes 25 mm dia, Red oxide Zinc chromate primer, GI trafford profile sheet 0.35mm thick, Bitumen washer, G.I Limpet washer, Galvanised steel J or L hooks 8 mm dia, Galvanised steel bolts & nuts 6 mm dia and 25 mm long round head with slots, White Vitreous china 10 lit. (full flush) capacity controlled low level flushing cistern with all fittings, PVC pipe 25 mm outer dia. 10kgf cm2, Solid blocks of size 30x20x20cm, Galvanised wire mesh of average width of aperture 1.4 and nominal dia. of wire 0.63 mm, Wire nails, Twisted steel/deformed bars, Structural steel such as tees, angles, channels and R.S. joists, Adjustable span ESO+SI (2.35-3.40), Adjustable telescopic prop 3 m (2.02-3.75m), Beam clamp 300-380 mm (450-1070 mm), Second class kail wood in planks, Second class kail wood in scantling, Hollock ballies 125 mm diameter, Safeda ballies 125 mm diameter, Average rate of mild steel round bars for reinforcements, Stone Aggregate(single size): 06 mm nominal size, Mild steel round bar 12 mm dia and below, Flats up to 10 mm in thickness, Anjili wood scantls, Bright finished or black enameled mild steel butt hinges 100x58x1.90 mm, Bright finished or black enameled mild steel butt hinges 50x37x1.50 mm, Bright finished or black enameled mild steel screws 40 mm, Bright finished or black enameled mild steel screws 20 mm, Anjili wood planks, Float glass sheet of nominal thickness 4 mm (weight not less than 10 kg/sqm), Factory made door frame size 50x47 mm with wall thickness 5 mm made of single piece extruded profile, 35 mm thick factory made solid panel PVC door shutter of single piece extruded profile non decorative finished (Matt finished), Powder coated M.S. butt hinges 100 mm X58 mm X 1.9 mm, Water thinnable cement primer for interior wall surface, having VOC content less than 50 gms/litre, Acrylic exterior paint, Exterior primer, Plastic emulsion paint, Pink primer (for wood), Synthetic enamel paint in black or chocolate shade, Vitrified floor tile 50x50 cm, Ceramic Glazed Tiles Ist quality minimum thickness 5 mm in all colours shades and designs except burgundy, bottle green black, Ceramic Glazed Tiles Ist quality 300 x 300 mm in all shades and designs of White, Ivory, grey, Fume Red brown etc., Polyethylene water storage tank with cover and suitable locking arrangemnet, 200 mm Aluminium aldrop, Anodised Aluminium tower bolt (barrel type)300x10 mm, Chromium plated Brass screws 30 mm, Vitreous china flat back wash basin 550x400 mm, 15 mm C.P.brass tap, C.P. brass waste 32 mm, C.I. bracket for wash basin and sinks, Semi Rigid PVC waste pipe for sink and wash basin 32 mm dia with length not less than 700 mm i/c PVC waste fittings, Stainless steel kitchen sink - without drain board 470x420 mm bowl depth 178 mm, Vitreous China orrisa type w.c. pan size 580 mm, Flushing Cistern P.V.C. 10 lts capacity (low level) (white) (with fittings, accessories and flush pipe), 100 mm S.C.I. trap with vent heel, Black plastic seat (soild) with lid C.P.brass hinges and rubber buffers, Vitreous china pedestal type wate closet, PVC pipe 25 mm outer dia. 10kgf cm2, PVC pipe 110 mm outer dia. 4kgf/cm2, PVC Elbow 110 mm dia, PVC door Elbow 110 mm dia, PVC bend 110 mm dia, PVC Tee 110x110x110mm dia, PVC vent cowl 110 mm dia, PVC end cap 110 mm dia, Hire charge of 10 HP engine and pump set, Diesel oil, Hydraulic Excavator (3D) with driver and fuel, Hire and running charges of loader, Puddle clay, Empty cement bag, Synthetic enamel paint in black or chocolate shade, Deharadun white lime, Interlocking C.C. paver block (80 mm thick, M-30), Galvanised steel plain sheets, Epoxy paint, Black Japan at Thrissur,Kerala,India